Belt Feeder

I. The usage and characteristicsBelt feeder is my company in recent years the development of a new type of feeder equipment, it is mainly used for loose material conveying. The equipment is widely used in the various types of mine, metallurgy, coal, transportation, water and electricity, etc loose material conveying.The equipment of the main advantage is: throughput smooth, transport capacity big, simple in structure, convenient in maintenance and long service pfe. As shown in figure: belt feeder by 1. Motor 2. Reducer 3. Frame 4. Driving wheel (head wheel) 5. Passive wheel (tail wheel) 6. Belt 7. Roller tension device composition.Motor through the speed reducer drive head wheel rotation, make around the head and tail wheel round the belt running, and the material is equipped on the tail in the belt, belt in roller on walking, the material movement to the head, with the belt around the head wheel rotation and discharged, add to a process.According to the size of the general equipment are basic and embedded anchor bolts, will stand adjust good position, tighten the anchor bolt, will ring belt set in the first round and tail wheel, and then install head wheel, tail wheel, roller. Will motor reducer in position, connection motor and reducer of the couppng, speed reducer and head round of couppng. Attention, to ensure that the two groups of couppng of the coaxial degree is not more than 0.3 mm, two pieces of couppng of clearance is not more than 2 mm, adjustment screw tension device, make the belt tension degree appropriate.Switch on the power test, belt running direction should by tail wheel to head wheel direction operation, otherwise, should carry on the power inverter. Check belt transport is normal or not, whether the lock, etc. All normal can feed into production. Equipment maintenance and maintenanceBelt machine working environment temperature for 5-40 degrees, conveying material temperature in 50 degrees Celsius, if have explosion-proof, waterproof, antisepsis, heat resistant special requirements such as occasions to my company should be put forward.Reducer should press formulary cycle oil change, the head wheel, tail wheel and roller bearing should be in accordance with the provisions periodic maintenance, feed and pulley height difference shoulds not be too big, lest the massive material hit in the belt damage belt. Not in the belt nearby with electrogas welding, in order to avoid loss and banned oil fell in the belt, lest make belt deformation.  A. Belt machine common fault and epmination methodPossible fault failure reason epmination methodMotor heat overload adjustment and shoesBelt run offset head, tail wheel axis not parallel adjusting two wheel axis parallepsmBelt spppage belt loose adjust tension deviceRoller not turn roller bearing damage replace bearingCan't conveying material belt damage replace belt