GXX High Efficiency Hydraulic Cyclone

FX6-250 Cyclone group‍Operation InstructionI. Equipment specifications model significanceDiameter 2. Quantity 3. Cyclone classificationCyclone Group made by the 6 cyclone combination, a centralized approach to mining, pulp from the distributor to evenly cyclone pulp supply. The use of manual valve control the each cyclone feeding, and their run-off and Chamber together in the overflow tank and the Chamber slot.II. Cyclone Group structure drawing1. Cyclone support  2. Cyclone 3. Tank4. Feed distributor  5. Pressure gaugeIII. Equipment useCyclone in the mineral processing operations for classification, sorting, concentration and desliming, etc. Cyclone is a non-power equipment, which is pumped by the materials will be sent to the cyclone, after a pressure The proportion of different materials separated to sorting results.Cyclone has the advantage of: ① simple, flexible and light, without moving parts. ② Low-cost equipment, easy disassembly, easy maintenance, small area, low cost infrastructure.③ Ability to deal with large unit volume.④ Classification Small size, up to about 10μm. ⑤Higherefficiency rating, etc.IV. Pressure adjustment：Adjust the pressure can make the material in the cyclone with different speed of rotation. When the feed pressure, rotational speed and materials, processing power, but not necessarily the best, because there are some slightly larger proportion of the materials emitted from the mouth overflow, causing the overflow mouth is running rough. When the feed pressure is small, rotating the centrifugal force of small materials, resulting in a small proportion of the material flow from the mouth at the end of discharge and reduced ability to deal with cyclone, so the adjustment should be based on actual requirements, choose the right pressure in order to achieve the best results sorting.V. The size of the overflow tube diameter: choose diameter is too large, run-off will result in too much material; diameter is too small, it will cause a material plug, it must choose the right specifications.VI. The size of discharge sand mouth diameter: with the overflow tube in the same way.VII. Cyclone technical parameters1、 Feeding particle max. size3mm;2、 Feeding pressure: 0.03-0.25MPa;3、 Separation particle size :40-100μm;4、Capacity (flow rate) 60m ³ / h;5、Pump requirement: choose Slurry pump or slime pump, flow rate >30% of the cyclone flow can be equipped with valves control ;6、Installing pressure gauge in the cyclone feed Department, , pressure can not be less than 0.05MPa, can not be higher than 0.3 MPa;VIII. Notes① it must be replaced when discharge sand mouth, Overflow tube serious wear in time, or it will affect election results and wear cone.② fastening bolts before uses.